Press the key to display the lower area again.
For each of the demand parameters you can view:
The maximum value, with the date and time when it occurred.
A bar chart with the indications of the instantaneous value, maximum and minimum
values and alarms, see “4.4.3. CENTRAL AREA”�
Table 26:Demand parameters (display 3 parameters)�
Icon
Display 3 parameters
Demand parameters�
Current L1
Current L2
Current L3
Active power L1
Active power L2
Active power L3
Apparent power L1
Apparent power L2
Apparent power L3
(
The following icons appear for all these parameters on the screen:
Indicating that the parameter refers to consumed or generated energy.
If the 2 icons light up at the same time, it means the installation is not properly connected.
The following icons also appear in the active power maximum demand parameters:
Indicating that the parameter refers to inductive or capacitive energy.
If there is an alarm associated with the variable being displayed, the following will be shown:
The module with which the alarm is associated.
The associated output in the module.
The alarm status: not activated, pre-alarm activated, alarm activated.
The icon flashes during the delay time in the alarm connection (ON) and
disconnection (OFF).
98
CVM-A1000 - CVM-A1500
Instruction Manual
To Next Page
Loading...
