Cirrus DESIGN SR22 - Balked Landing;Go-Around; After Landing

Cirrus Design Section 4
SR22 Normal Procedures
P/N 13772-002 4-21P/N 13772-002 4-21
Balked Landing/Go-Around
In a balked landing (go around) climb, disengage autopilot, apply full
power, then reduce the flap setting to 50%. If obstacles must be
cleared during the go around, climb at 75-80 KIAS with 50% flaps.
After clearing any obstacles, retract the flaps and accelerate to the
normal flaps up climb speed.
1. Autopilot .....................................................................DISENGAGE
2. Power Lever ........................................................ FULL FORWARD
3. Flaps ........................................................................................50%
4. Airspeed........................................................................75-80 KIAS
After clear of obstacles:
5. Flaps ......................................................................................... UP
After Landing
1. Power Lever ................................................................... 1000 RPM
2. Fuel Pump ............................................................................... OFF
3. Flaps .......................................................................................... UP
4. Transponder ...........................................................................STBY
5. Lights ..................................................................... AS REQUIRED
6. Pitot Heat ................................................................................. OFF
• Note •
As the airplane slows the rudder becomes less effective and
taxiing is accomplished using differential braking.
Reissue A