EasyManua.ls Logo

Cirrus DESIGN SR22 - Shutdown

Cirrus DESIGN SR22
484 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4-22 P/N 13772-002
Section 4 Cirrus Design
Normal Procedures SR22
Shutdown
1. Fuel Pump (if used) .................................................................OFF
2. Throttle .................................................................................... IDLE
• Caution •
Note that the engine hesitates as the switch cycles through
the “OFF” position. If the engine does not hesitate, one or both
magnetos are not grounded. Prominently mark the propeller
as being “Hot, and contact maintenance personnel
immediately.
3. Ignition Switch.....................................................................CYCLE
4. Mixture ............................................................................. CUTOFF
5. All Switches..............................................................................OFF
6. Magnetos .................................................................................OFF
7. ELT........................................................... TRANSMIT LIGHT OUT
• Note •
After a hard landing, the ELT may activate. If this is suspected,
press the RESET button.
8. Chocks, Tie-downs, Pitot Covers ........................... AS REQUIRED
Reissue A

Table of Contents

Related product manuals