Cirrus DESIGN SR22 - Left;Right Brake Over-Temperature Annunciation

Cirrus Design Section 3
SR22 Emergency Procedures
P/N 13772-002 3-31P/N 13772-002 3-31
Left/Right Brake Over-Temperature Annunciation
BRAKE TEMP Warning
1. Stop aircraft and allow the brakes to cool.
Amplification
Annunciation indicates brake temperature is greater than 293°F. Refer
to Section 10, Taxiing, Steering, and Braking Practices for additional
information.
Starter Engaged Annunciation
STARTER ENGAGED Warning
On-Ground
1. Ignition Switch............................................................DISENGAGE
2. Battery Switches ............... Wait 1 minute before next start attempt
If starter does not disengage (relay or solenoid failure):
3. BAT 1 Switch............................................................................ OFF
4. Engine........................................................................ SHUTDOWN
5. STARTER Circuit breaker ...................................................... PULL
In-Flight
1. Ignition Switch...................................... Ensure not stuck in START
2. STARTER Circuit breaker ...................................................... PULL
3. Flight ............................................................................ CONTINUE
Engine start will not be available at destination.
(Continued on following page)
BRAKE TEMP
START ENGAGE
Reissue A