Cirrus DESIGN SR22 - Page 307

Cirrus Design Section 8
SR22 Handling and Servicing
P/N 13772-002 8-31P/N 13772-002 8-31
Instrument Panel and Electronic Display Screens
The instrument panel, control knobs, and plastic trim need only to be
wiped clean with a soft damp cloth. The multifunction display, primary
flight display, and other electronic display screens should be cleaned
with Optimax - LCD Screen Cleaning Solution as follows:
• Caution •
To avoid solution dripping onto display and possibly migrating
into component, apply the cleaning solution to cloth first, not
directly to the display screen.
Use only a lens cloth or nonabrasive cotton cloth to clean
display screens. Paper towels, tissue, or camera lens paper
may scratch the display screen.
Clean display screen with power OFF.
1. Gently wipe the display with a clean, dry, cotton cloth.
2. Moisten clean, cotton cloth with cleaning solution.
3. Wipe the soft cotton cloth across the display in one direction,
moving from the top of the display to the bottom. Do not rub
harshly.
4. Gently wipe the display with a clean, dry, cotton cloth.
Headliner and Trim Panels
The airplane interior can be cleaned with a mild detergent or soap and
water. Harsh abrasives or alkaline soaps or detergents should be
avoided. Solvents and alcohols may damage or discolor vinyl or
urethane parts. Cover areas where cleaning solution could cause
damage. Use the following procedure:
• Caution •
Solvent cleaners and alcohol should not be used on interior
parts. If cleaning solvents are used on cloth, cover areas
where cleaning solvents could cause damage.
1. Clean headliner, and side panels, with a stiff bristle brush, and
vacuum where necessary.
2. Soiled upholstery, may be cleaned with a good upholstery cleaner
suitable for the material. Carefully follow the manufacturer's
instructions. Avoid soaking or harsh rubbing.
Reissue A