Cirrus DESIGN SR22 - Section 4 - Normal Procedures; PreFlight Inspection

P/N 13772-141 7 of 20
Cirrus Design Section 9
SR22 / SR22T Supplements
Section 4 - Normal Procedures
• Note •
Additional normal operating procedures for the System Fifty
Five SR are described in the S-Tec System Fifty Five SR
Pilot’s Operating Handbook.
PreFlight Inspection
1. Manual Electric Trim ..............................................................TEST
Press the AP DISC button down and hold while commanding trim.
Trim should not operate either nose up or nose down.
2. Engage Autopilot Heading Mode ....................... Press HDG button
3. Engage Autopilot Altitude Hold Mode ..................Press ALT button
4. Autopilot Override ..................................................................TEST
Move flight controls fore, aft, left and right to verify that the
autopilot can be overpowered.
5. Disengage Autopilot.....................................Press AP DISC button
6. Trim ................................................................ SET FOR TAKEOFF
7. Autopilot RDY Light...................................................... CHECK ON
8. Trim airplane for existing flight conditions.
Revision 01: 01-06-10