10-12 P/N 13772-005
Section 10 Cirrus Design
Safety Information SR22T
• Use only as much power (throttle) as is necessary to achieve
forward movement. Keep in mind, any additional power added
with the throttle will be absorbed in the brakes to maintain
constant speed.
•Use rudder deflection and the minimum necessary inputs of
differential braking to achieve directional control.
• Do not “ride the brakes”. Pilots should consciously remove
pressure from the brakes while taxiing. Failure to do so results in
excessive heat buildup, premature brake wear, and increased
possibility of brake failure or fire.
•Avoid unnecessary high-speed taxiing. High-speed taxiing may
result in excessive demands on the brakes, increased brake
wear, and the possibility of brake failure or fire.
• Brakes have a large energy absorbing capacity; therefore,
cooling time should be considered. Energy absorbed during a
few seconds of deceleration can take up to an hour to dissipate.
Always allow adequate cooling time after brake use.
•Allow a cooling period following a high-energy braking event.
High-energy braking can include an aborted takeoff or the
equivalent energy required for a Maximum Gross Weight full-
stop from 70 knots in less than 1000 feet.
Brake Maintenance
The brake assemblies and linings should be checked at every oil
change (50 hours) for general condition, evidence of overheating, and
deterioration. Refer to Section 8, Landing Gear Servicing for specific
servicing information on the Brake System.
Original Issue
To Previous Page
Loading...
Need help?
General
