Cirrus Design Section 7
SR22T Systems Description
P/N 13772-005 7-27P/N 13772-005 7-27
Seats
The seating arrangement consists of two individually adjustable seats
for the pilot and front seat passenger and a “2+1” configuration with a
one-piece bench seat and fold-down seat backs for the rear seat
passengers.
• Caution •
Do not kneel or stand on the seats. The seat bottoms have an
integral aluminum honeycomb core designed to crush under
impact to absorb downward loads.
Front Seats
The front seats are adjustable fore and aft and the seat backs can be
reclined for passenger comfort or folded forward for rear seat access.
Integral headrests are provided. The fore and aft travel path is
adjusted through the seat position control located below the forward
edge of the seat cushion. The seat track is angled upward for forward
travel so that shorter people will be positioned slightly higher as they
adjust the seat forward. Recline position is controlled through levers
located on each side of the seat backs. Depressing the recline release
control while there is no pressure on the seat back will return the seat
back to the full up position.
To position front seat fore and a ft:
1. Lift the position control handle.
2. Slide the seat into position.
3. Release the handle and check that the seat is locked in place.
To adjust recl ine posi tion:
1. Actuate and hold the seat back control lever.
2. Position the seat back to the desired angle.
3. Release the control lever.
Rear Seats
The rear seats employ a one-piece bench seat and two seat backs
configured in 60/40 split. This “2+1” seating configuration provides for
a center seat/restraint area for a third passenger on the wider left hand
seat.
Each seat back reclines independently of each other and can be
folded forward to provide a semi-flat surface for cargo extending
Original Issue
To Next Page
Loading...
Need help?
General
