Cirrus SR22T - Shutdown

4-26 P/N 13772-005
Section 4 Cirrus Design
Normal Procedures SR22T
Shutdown
1. Fuel Pump (if used)..................................................................OFF
2. Throttle....................................................................................IDLE
3. Ignition Switch.....................................................................CYCLE
4. Mixture ............................................................................. CUTOFF
5. All Switches..............................................................................OFF
6. Magnetos .................................................................................OFF
7. ELT........................................................... TRANSMIT LIGHT OUT
8. Chocks, Tie-downs, Pitot Covers ........................... AS REQUIRED
Amplification
• Caution •
Note that the engine hesitates as the switch cycles through
the “OFF” position. If the engine does not hesitate, one or both
magnetos are not grounded. Prominently mark the propeller
as being “Hot,” and contact maintenance personnel
immediately.
After a hard landing, the ELT may activate. If this is suspected, press
the RESET button.
Original Issue