Cirrus Design Section 8
SR22T Handling and Servicing
P/N 13772-005 8-25P/N 13772-005 8-25
Cleaning and Care
Cleaning Exterior Surfaces
• Caution •
Airplane serials with Ice Protection System: Do not wax
leading edge porous panels. Refer to Section 9: Log of
Supplements of this handbook for instructions and limitations
for airplanes equipped with the Ice Protection System.
• Note •
Prior to cleaning, place the airplane in a shaded area to allow
the surfaces to cool.
The airplane should be washed with a mild soap and water. Harsh
abrasives or alkaline soaps or detergents could make scratches on
painted or plastic surfaces or could cause corrosion of metal. Cover
static ports and other areas where cleaning solution could cause
damage. Be sure to remove the static port covers before flight. To
wash the airplane, use the following procedure:
1. Flush away loose dirt with water.
2. Apply cleaning solution with a soft cloth, a sponge or a soft bristle
brush.
3. To remove exhaust stains, allow the solution to remain on the
surface longer.
4. To remove stubborn oil and grease, use a cloth dampened with
naphtha.
5. Rinse all surfaces thoroughly.
Any good silicone free automotive wax may be used to preserve
painted surfaces. Soft cleaning cloths or a chamois should be used to
prevent scratches when cleaning or polishing. A heavier coating of
wax on the leading surfaces will reduce the abrasion problems in these
areas.
Original Issue
To Next Page
Loading...
Need help?
General
