Cisco 1242AG - Aironet - Wireless Access Point - Appendix C Access Point Specifications; Access Point Specifications

C-1
Cisco Aironet 1240AG Series Access Point Hardware Installation Guide
OL-8371-05
APPENDIX
C
Access Point Specifications
Table C-1 lists the technical specifications for the 1240AG series access point.
Table C-1 Access Point Specifications
Category
802.11G Radio Specifications
802.11A Radio Specifications802.11b 802.11g
Size 6.6 in. W x 8.5 in. D x 1.1 in. H
16.8 cm W x 21.6 cm D x 2.8 cm H
Indicators Three indicators on the 2.4 Ghz end panel: Ethernet traffic, status, and radio traffic.
Connectors 2.4 GHz end panel (left to right)
Left RP-TNC antenna connector; RJ-45 connector for serial console port connections; RJ-45
connector for 10BASE-T or 100BASE-T Ethernet connections; power connector (for plug-in
48VDC AC power module); right (primary) RP-TNC antenna connector.
5-GHz end panel (left to right)
Left RP-TNC antenna connector; right (primary) RP-TNC antenna connector.
Input Voltage 48 VDC (nominal)
Input Power 12.95 W (Up to 15.4 W with a 100 m CAT 5 Ethernet cable)—maximum
Operating Temperature Base unit:
–4 to 113
o
F (–20 to 45
o
C) without mounting bracket installed
–4 to 131
o
F (–20 to 55
o
C) with mounting bracket installed
1240AG series power module:
32 to 104
o
F (0 to 40
o
C)
Storage Temperature -40 to 185
o
F (-40 to 85
o
C)
Humidity 10 to 90% non-condensing
Weight Without mounting hardware:
2 lbs (0.9 kg)
Modulation Complementary Code Keying
(CCK)
Orthogonal Frequency Division Multiplex (OFDM)
Subcarrier modulation BPSK (1 Mbps)
QPSK (2 Mbps)
CCK (5.5 and 11 Mbps)
BPSK (6 and 9 Mbps)
QPSK (12 and 18 Mbps)
16-QAM (24 and 36 Mbps)
64-QAM (48 and 54 Mbps)
BPSK (6 Mbps and 9 Mbps)
QPSK (12 Mbps and 18 Mbps)
16-QAM (24 and 36 Mbps)
64-QAM (48 and 54 Mbps)