7-10
Cisco TelePresence System 3000
OL-14521-01
Chapter 7 Assembling the Remaining Cisco TelePresence Elements
Parts List
Step 5 Attach the Projector bracket to the underside of the center Table segment.
Note • The bracket slides between two rows of screws. Screw the six screws with washers into the underside
of the center table segment and slide the bracket between the two rows of screws; then, tighten the
screws.
• There is a channel that is cut into the underside of the table. Route the cable for the center
microphone into this channel, using tape or another method, so that the microphone cable is not
pinched between the bracket and the table.
Figure 7-5 Projector Assembly
To Next Page
Loading...
