11-25
Cisco TelePresence System 3000
OL-14521-01
Chapter 11 Field-Replaceable Unit Guide
Replacing the Projector—Part Number CTS-PRJTR-GEN1=
Note You may need to rock the unit backward and forward to unseat it.
Step 9 Install the replacement lamp module and secure the module and cover with the screws.
Step 10 Place the projector and bracket in position on the bottom of the table and slide the assembly into place.
Step 11 Tighten the screws that secure the mounting bracket and replace the two screws at the rear of the bracket.
Step 12 Reattach the power, video, and signal cables.
Step 13 Turn the power switch on the underside of the projector to the ON position.
Step 14 Reset the lamp replacement counter by completing the following steps:
a. Press the MENU button to display the on-screen menu.
Note You can either use the remote or press the button on the projector to perform these steps. The
MENU and other buttons are on the underside of the projector after you attach it to the table.
b. Use the Up and Down arrow keys to select Setting.
c. Use the Right and Left arrow keys to select Lamp counter reset.
d. When you are prompted to reset the lamp counter, Select Yes and press the OK button.
e. Select Yes and press the OK button to reconfirm your choice.
Replacing the Projector—Part Number CTS-PRJTR-GEN1=
Step 1 Power off the projector by turning off the power switch located on the back of the unit.
Step 2 Unplug the VGA cable from the back of the unit.
Step 3 Unplug the power cable from the back of the unit.
Step 4 Remove two of the six screws that hold the projector assembly to the underside of the center tabletop.
These screws are the rear-most of the six screws and the furthest away from the projector lens.
Step 5 Loosen the remaining four mounting screws.
Note You might have to remove the screws and remove the assembly during this step, rather than loosen the
screws. Be sure to secure the projector when you remove the screws.
Step 6 Remove the projector assembly by sliding the unit to the side until the projector mounting bracket
disengages from the loosened mounting screws.
Note On some CTS 3000 models, you remove the projector assembly by sliding it to the front, rather than the
side.
Step 7 Remove the screws that attach the mounting plate to the projector and remove the plate.
Step 8 Attach the mounting plate to the replacement projector.
To Next Page
Loading...
