11-4
Cisco TelePresence System 3000
OL-14521-01
Chapter 11 Field-Replaceable Unit Guide
Replacing the Camera Cluster—Part Number CTS3K-CAM-CLST-G2=
Replacing the Camera Cluster—Part Number
CTS3K-CAM-CLST-G2=
Required Information, Tools, and Equipment
To remove and replace the camera cluster for the Cisco TelePresence 3000, you need the following
information, tools, and equipment:
• The Cisco TelePresence System Administrator's Guide for your software release
• The Release Notes for Cisco TelePresence System for your software release
• Power screwdriver with 2.5, 3, and 6 mm (standard or round) Allen bits, or standard 2.5, 3, and 6 mm
Allen wrenches
• 0.9mm Allen wrench for camera lens adjustments (if the lens uses a thumbscrew, no tools are
required)
• Manual screwdrivers, Phillips and flat head types
• Metric wrenches, 10 to 15 mm
• Masking tape
• Laptop computer attached to network
Powering Off the System
Power off the system by turning the power switches to the Off position on the two left PDUs, single right
PDU and, if present, the PDU or auxiliary control unit behind the center display assembly.
Caution Make sure all system power is turned off before beginning this disassembly.
Removing the Camera Cluster
Note Make sure to retain all screws, brackets, and other parts during the disassembly.
Caution Take care not to scratch or mar the display screen during the replacement procedure.
CTS-PRJTR-JC-GEN1= Jumper Cord From the projector
CTS-PWR-PDU= Power Distribution Unit for the Cisco TelePresence Systems
Table 11-1 List of FIeld-Replaceable Units for the Cisco TelePresence System (continued)
FRU Part Number Description
To Next Page
Loading...
