11-21
Cisco TelePresence System 3000
OL-14521-01
Chapter 11 Field-Replaceable Unit Guide
Replacing a Light Fixture—Part Number CTS-LIGHT-FIXT=
Step 13 Select Hardware Setup to verify the cameras, displays, speakers, and microphones are working
properly.
Refer to the Cisco TelePresence System Administrator's Guide for your software release for more
information.
Step 14 If required, reattach the projector assembly.
See Chapter 7, “Assembling the Remaining Cisco TelePresence Elements” for more information.
Step 15 Perform the microphone test to verify that the microphone is working properly.
See the “Setting Up the Microphones” section on page 9-17 for more information.
Replacing a Light Fixture—Part Number CTS-LIGHT-FIXT=
Required Information, Tools, and Equipment
To disassemble and reassemble portions of the Cisco TelePresence 3000, you need the following
information, tools, and equipment:
• Cisco TelePresence System Release 1.4 Administrator’s Guide, OL-13676-03
• Power screwdriver with 2.5, 3, and 6 mm (standard or round) Allen bits, or standard 2.5, 3, and 6 mm
Allen wrenches
Tip A round-head Allen bit allows the bit to work at an angle instead of only straight out, which is
helpful in tight spots.
• Manual screwdrivers, Phillips and flat head types
• Metric wrenches, 10 to 15 mm
• Masking tape
• Step stool or small step ladder
• Laptop computer attached to network (for troubleshooting or reference)
Replacement Bulbs
A Field Replacement Unit consisting of three 5-foot and two 4-foot 4100 K bulbs is available from Cisco
Customer Service. The part number is CTS-3000-BULBS.
If one or more bulbs need replacement, it is recommended that all five bulbs are replaced for lighting
uniformity.
Note The light fixtures installed during assembly have a 4100 K rating. If you set the Plasma display to
another value you need to purchase and replace the light fixtures to match the new color temperature
setting.
To Next Page
Loading...
