Cisco 3000 - Focusing the Camera

9-13
Cisco TelePresence System 3000
OL-14521-01
Chapter 9 First-Time Setup
Setting Up CTS Components
Focusing the Camera
To focus the cameras using the large and small targets, complete the following steps:
Step 1 Place the small target on center of the table, in front of the center camera.
Step 2 Arrange the large target five feet (152 cm) behind the small target.
Tip Use a chair to prop up the large target.
Figure 9-8 Arranging the Small and Large Targets
Step 3 In the Cisco TelePresence Administrative GUI, click Setup, then click Show Focus Target.
Step 4 Adjust the small target so that the red box encloses the upper patterns on the large target and the green
box encloses the patterns on the small target.
Figure 9-9 Positioning the Small and Large Targets
207151
Large target
Small target
10 ft
5 ft
206146
Red
rectangle
Green
rectangle
Large
target
Small
target
Red and green
horizontal bars