9-12
Cisco TelePresence System 3000
OL-14521-01
Chapter 9 First-Time Setup
Setting Up CTS Components
i. Make manual adjustments to the camera focused on the target and the zoom ring on the camera to
make the following adjustments to the camera:
• Align the red plus sign to the plus sign in the middle of the target.
• Align the red hash marks on the display so that they fit between the table edges.
• Zoom and align the camera so that the curved line on the left side of the display touches the red
adjustment line at the right edge of the display
Figure 9-7.
To adjust the camera left and right or up and down, or to make vertical adjustments, use the
adjusting screws as shown in
Figure 9-4.
Note If one of the left/right screws is covered by the camera cable, use the other screw to make
all left/right adjustments.
Figure 9-7 Correct Camera Target Alignment—Left Display
j. Place the small target on the table, in front of the large target, and adjust the focus by completing
the steps in the
“Focusing the Camera” section on page 9-13.
Step 5 Tighten the thumbscrew on the zoom and focus rings.
Step 6 Click Hide Camera Target to remove the alignment images.
Step 7 To complete the zoom procedure, click Done.
Step 8 Click Setup, then click Auto Adjust to automatically adjust the camera settings.
You will see various images and colors on the displays during the adjustment. Auto Adjust takes
approximately 1 minute.
Red plus
sign within
black cross
Red lines
Table
edge
Red
Vertical line
205766
To Next Page
Loading...
