CHAPTER
10-1
Cisco TelePresence System 3000
OL-14521-01
10
Use & Care Guide
Revised: October 31, 2008, OL-14521-01
Maintaining the Tabletop
Caution Waxing or rubbing the surface with any type of abrasive is not recommended.
• For general daily care - use a dampened cloth with clean water.
• To remove dirt - use a mild soap and water solution. Wipe off with clean water afterward to remove
the soap.
• To remove ink marks - rub the stained area with a pencil eraser.
• To polish the tabletop - use lemon oil.
Note Lemon oil is not recommended for daily use.
Cleaning the Plasma displays
Per industry-standard best practice recommendations for cleaning plasma displays:
The plasma displays require special consideration when cleaning. Wipe the panel surface gently using
only a cleaning cloth or a soft, lint-free cloth. If the surface is particularly dirty, wipe with a soft, lint-free
cloth which has been soaked in pure water or water to which a small amount of neutral detergent has
been added, and then wipe it evenly with a dry cloth of the same type until the surface is dry.
Cleaning the Camera lens
Caution Do not touch the camera after installation is completed. If you need to clean the camera lens, use a dry
microfiber cloth. After cleaning, you will need to realign the camera.
To Next Page
Loading...
