8-14
Cisco TelePresence System 3000
OL-14521-01
Chapter 8 Routing Power and Signal Cables
Power Requirements for the Cisco TelePresence 3000
Step 11 Attach and route the power and signal cables for the plasma displays.
Note Connect the center plasma display to “UNSWITCHED” outlet of the the auxiliary control unit.
Figure 8-11 Cabling the Plasma displays
Note Figure 8-11 displays the rear view of the Cisco TelePresence System 3000. Left and right are reversed.
Tip Before you plug cables into a Codec or PDU, label each cable.
To Next Page
Loading...
