8-16
Cisco TelePresence System 3000
OL-14521-01
Chapter 8 Routing Power and Signal Cables
Power Requirements for the Cisco TelePresence 3000
Step 13 Attach the ferrite cores to the ends of all six camera cables (both the video and Ethernet cables, 12 ferrite
cores total).
Wrap the cables around the ferrite as shown in Figure 8-13. Attach the ferrite cores so that they are
approximately 1 1/2 inches (4 cm) from the connectors.
Figure 8-13 Connecting the Ferrite Cores
Step 14 Connect the cables between the primary and secondary codecs.
Note If you ordered a Presentation Codec or Auxiliary Control Unit with your TelePresence system, see
Figure 8-16 for additional cabling information.
To Next Page
Loading...
