Cisco 3000 - Page 155

8-19
Cisco TelePresence System 3000
OL-14521-01
Chapter 8 Routing Power and Signal Cables
Power Requirements for the Cisco TelePresence 3000
Cable routing for a standard CTS-3000 installation that uses a presentation codec is shown in
Figure 8-16. Refer to the “Options for the Cisco TelePresence System 3000” chapter of the Cisco
TelePresence Hardware Options and Upgrade Guide for more information about the presentation codec.
Figure 8-16 Cable Routing for CTS-3000 with Presentation Codec
Step 15 (Optional) If your installation uses an optional external display or a document camera, install and route
the cabling.
204192
12
12
10/100 NETWO RK PO RTSRESETSERIAL PO RTS
Primary Codec
Auxiliary Control Unit
Projector
Presentation Codec
Auxiliary Video Out
Camera
IP Phone
Auxiliary
network
port
Network
Left Right
Document Camera
Left Codec
Right Codec
Center
Display
Auxiliary Video In
Auxiliary Video In
Video out
Video InSerial
First Row
Center Microphone
Audio Expansion
Unit
Speaker
Serial 2
Serial 1
Ethernet 1
Ethernet 2
Signal