8-22
Cisco TelePresence System 3000
OL-14521-01
Chapter 8 Routing Power and Signal Cables
Power Requirements for the Cisco TelePresence 3000
Refer to the “Options for the Cisco TelePresence System 3000” chapter of the Cisco TelePresence
Hardware Options and Upgrade Guide for more information about the presentation codec.
Note Because you need to split the video signal between the projector and any additional video output, you
must purchase at least one extra cable to connect optional external display(s). Cables for the external
displays and document camera are not included with the standard Cisco TelePresence installation.
Note When you use the audio/video extension unit as a video splitter, connect port 1 of the “Video in”
connection from the presentation codec, and port 4 of the “Video out” connection to the projector.
To Next Page
Loading...
