9-15
Cisco TelePresence System 3000
OL-14521-01
Chapter 9 First-Time Setup
Setting Up CTS Components
Caution Do not overtighten the screws, or use a power screwdriver to tighten the screws. The recommended
torque for the screws is 0.8N.m (7 inch-pounds).
In addition, make sure that you use screws of the correct length (20 mm). Overtightening the screws, or
using a screw that is too long, can cause the plastic hoods to break.
Figure 9-11 Attaching the Camera Hood Assembly
To Next Page
Loading...
