11-9
Cisco TelePresence System 3000
OL-14521-01
Chapter 11 Field-Replaceable Unit Guide
Replacing a Plasma Display—Part Number CTS-DISP-65-GEN4=
See Chapter 8, “Routing Power and Signal Cables”, for cable locations and reference.
Step 2 Detach the display screen’s power cable from the display and from the correct PDU.
See Chapter 8, “Routing Power and Signal Cables”, for cable locations and reference.
Step 3 Remove the black tape from the seam behind and between the display screens.
Step 4 Remove the left and right Display tilt brackets from the Display shelf supports.
Step 5 Using a minimum of two people, lift the Plasma display straight up to disengage the hooks on the back
of the display from the horizontal mounting rod on the Display structure.
Step 6 Remove the display mounting bracket by removing six screws. Set the bracket aside for use with the
replacement display.
Figure 11-1 Removing the Display Mounting Bracket
Step 7 Move the Plasma display out of the work area to a temporary location safe from potential damage.
Step 8 Unpack the new display.
Note Take care to minimize damaging the packaging material so it may be reused to package the old
display screen.
Step 9 Attach the display mounting bracket you removed from the original display using six screws, and remove
the display handles.
343347
To Next Page
Loading...
