Cisco 3750G - Catalyst Integrated Wireless LAN Controller - Page 13

Contents
xiii
Catalyst 3750 Switch Software Configuration Guide
OL-8550-02
Using Interface Configuration Mode 11-10
Procedures for Configuring Interfaces 11-11
Configuring a Range of Interfaces 11-12
Configuring and Using Interface Range Macros 11-13
Configuring Ethernet Interfaces 11-15
Default Ethernet Interface Configuration 11-15
Configuration Guidelines for 10-Gigabit Ethernet Interfaces 11-17
Configuring Interface Speed and Duplex Mode 11-17
Speed and Duplex Configuration Guidelines 11-17
Setting the Interface Speed and Duplex Parameters 11-18
Configuring IEEE 802.3x Flow Control 11-19
Configuring Auto-MDIX on an Interface 11-20
Configuring a Power Management Mode on a PoE Port 11-21
Budgeting Power for Devices Connected to a PoE Port 11-23
Adding a Description for an Interface 11-24
Configuring Layer 3 Interfaces 11-25
Configuring the System MTU 11-27
Monitoring and Maintaining the Interfaces 11-28
Monitoring Interface Status 11-29
Clearing and Resetting Interfaces and Counters 11-30
Shutting Down and Restarting the Interface 11-30
CHAPTER 12 Configuring Smartports Macros 12-1
Understanding Smartports Macros 12-1
Configuring Smartports Macros 12-2
Default Smartports Macro Configuration 12-2
Smartports Macro Configuration Guidelines 12-3
Creating Smartports Macros 12-4
Applying Smartports Macros 12-5
Applying Cisco-Default Smartports Macros 12-6
Displaying Smartports Macros 12-8
CHAPTER 13 Configuring VLANs 13-1
Understanding VLANs 13-1
Supported VLANs 13-2
VLAN Port Membership Modes 13-3