14-11
Catalyst 3750 Switch Software Configuration Guide
OL-8550-02
Chapter 14 Configuring VTP
Configuring VTP
This example shows how to use VLAN database configuration mode to configure the switch as a VTP
server with the domain name eng_group and the password mypassword:
Switch# vlan database
Switch(vlan)# vtp server
Switch(vlan)# vtp domain eng_group
Switch(vlan)# vtp password mypassword
Switch(vlan)# exit
APPLY completed.
Exiting....
Switch#
Configuring a VTP Client
When a switch is in VTP client mode, you cannot change its VLAN configuration. The client switch
receives VTP updates from a VTP server in the VTP domain and then modifies its configuration
accordingly.
Note If extended-range VLANs are configured on the switch stack, you cannot change VTP mode to client.
You receive an error message, and the configuration is not allowed.
Caution If all switches are operating in VTP client mode, do not configure a VTP domain name. If you do, it is
impossible to make changes to the VLAN configuration of that domain. Therefore, make sure you
configure at least one switch as a VTP server.
Beginning in privileged EXEC mode, follow these steps to configure the switch as a VTP client:
Use the no vtp mode global configuration command to return the switch to VTP server mode. To return
the switch to a no-password state, use the no vtp password privileged EXEC command. When you
configure a domain name, it cannot be removed; you can only reassign a switch to a different domain.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
vtp mode client Configure the switch for VTP client mode. The default setting is VTP
server.
Step 3
vtp domain domain-name (Optional) Enter the VTP administrative-domain name. The name can be 1
to 32 characters. This should be the same domain name as the VTP server.
All switches operating in VTP server or client mode under the same
administrative responsibility must be configured with the same domain
name.
Step 4
vtp password password (Optional) Enter the password for the VTP domain.
Step 5
end Return to privileged EXEC mode.
Step 6
show vtp status Verify your entries in the VTP Operating Mode and the VTP Domain Name
fields of the display.
To Next Page
Loading...
Need help?
General
