EasyManuals Logo

Cisco 3750G - Catalyst Integrated Wireless LAN Controller User Manual

Cisco 3750G - Catalyst Integrated Wireless LAN Controller
1204 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #385 background imageLoading...
Page #385 background image
14-13
Catalyst 3750 Switch Software Configuration Guide
OL-8550-02
Chapter 14 Configuring VTP
Configuring VTP
transparent VLAN database configuration command to return the switch to VTP server mode. If
extended-range VLANs are configured on the switch, you cannot change VTP mode to server. You
receive an error message, and the configuration is not allowed.
Enabling VTP Version 2
VTP Version 2 is disabled by default on VTP Version 2-capable switches. When you enable VTP
Version 2 on a switch, every VTP Version 2-capable switch in the VTP domain enables Version 2. You
can only configure the version when the switches are in VTP server or transparent mode.
Caution VTP Version 1 and VTP Version 2 are not interoperable on switches in the same VTP domain. Every
switch in the VTP domain must use the same VTP version. Do not enable VTP Version 2 unless every
switch in the VTP domain supports Version 2.
Note In TrCRF and TrBRF Token ring environments, you must enable VTP Version 2 for Token Ring VLAN
switching to function properly. For Token Ring and Token Ring-Net media, VTP Version 2 must be
disabled.
For more information on VTP version configuration guidelines, see the “VTP Version” section on
page 14-9.
Beginning in privileged EXEC mode, follow these steps to enable VTP Version 2:
To disable VTP Version 2, use the no vtp version global configuration command.
Note You can also enable VTP Version 2 by using the vlan database privileged EXEC command to enter
VLAN database configuration mode and by entering the vtp v2-mode VLAN database configuration
command. To disable VTP Version 2, use the no vtp v2-mode VLAN database configuration command.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
vtp version 2 Enable VTP Version 2 on the switch.
VTP Version 2 is disabled by default on VTP Version 2-capable switches.
Step 3
end Return to privileged EXEC mode.
Step 4
show vtp status In the VTP V2 Mode field of the display, verify that VTP Version 2 is enabled.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 3750G - Catalyst Integrated Wireless LAN Controller and is the answer not in the manual?

Cisco 3750G - Catalyst Integrated Wireless LAN Controller Specifications

General IconGeneral
Switching Capacity32 Gbps
RAM128 MB
Flash Memory32 MB
Power DeviceInternal power supply
Ports48 x 10/100/1000 + 4 x SFP
Performance38.7 Mpps
Wireless LAN Controller Capacity50
StackingYes
FeaturesVLAN support, QoS
Compliant StandardsIEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Humidity10% to 85% non-condensing
Power over Ethernet (PoE)Yes (optional)

Related product manuals