36-23
Catalyst 3750 Switch Software Configuration Guide
OL-8550-02
Chapter 36 Configuring IPv6 Unicast Routing
Displaying IPv6
This is an example of the output from the show ipv6 cef privileged EXEC command:
Switch# show ipv6 cef
::/0
nexthop 3FFE:C000:0:7::777 Vlan7
3FFE:C000:0:1::/64
attached to Vlan1
3FFE:C000:0:1:20B:46FF:FE2F:D940/128
receive
3FFE:C000:0:7::/64
attached to Vlan7
3FFE:C000:0:7::777/128
attached to Vlan7
3FFE:C000:0:7:20B:46FF:FE2F:D97F/128
receive
3FFE:C000:111:1::/64
attached to FastEthernet1/0/11
3FFE:C000:111:1:20B:46FF:FE2F:D945/128
receive
3FFE:C000:168:1::/64
attached to FastEthernet2/0/43
3FFE:C000:168:1:20B:46FF:FE2F:D94B/128
receive
3FFE:C000:16A:1::/64
attached to Loopback10
3FFE:C000:16A:1:20B:46FF:FE2F:D900/128
receive
<output truncated>
This is an example of the output from the show ipv6 protocols privileged EXEC command:
Switch# show ipv6 protocols
IPv6 Routing Protocol is “connected”
IPv6 Routing Protocol is “static”
IPv6 Routing Protocol is “rip fer”
Interfaces:
Vlan6
FastEthernet2/0/4
FastEthernet2/0/11
FastEthernet1/0/12
Redistribution:
None
This is an example of the output from the show ipv6 rip privileged EXEC command:
Switch# show ipv6 rip
RIP process "fer", port 521, multicast-group FF02::9, pid 190
Administrative distance is 120. Maximum paths is 16
Updates every 30 seconds, expire after 180
Holddown lasts 0 seconds, garbage collect after 120
Split horizon is on; poison reverse is off
Default routes are not generated
Periodic updates 9040, trigger updates 60
Interfaces:
Vlan6
FastEthernet2/0/4
FastEthernet2/0/11
FastEthernet1/0/12
Redistribution:
None
To Next Page
Loading...
Need help?
General
