EasyManuals Logo

Cisco 4500M User Manual

Cisco 4500M
608 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #113 background imageLoading...
Page #113 background image
6-13
Software Configuration Guide—Release 12.2(25)EW
OL-6696-01
Chapter 6 Configuring Supervisor Engine Redundancy Using RPR and SSO
Performing a Software Upgrade
This example shows how to perform a software upgrade:
Switch# config terminal
Switch(config)# config-register 0x2
Switch(config)# boot system flash slot0:cat4000-i5s-mz.122-20.EWA
Switch(config)# redundancy
Switch(config-red)# main-cpu
Switch(config-r-mc)# auto-syn standard
Switch(config-r-mc)# end
Switch# copy running-config start-config
Switch# redundancy reload peer
Switch# redundancy force-switchover
Switch#
This example illustrates how to verify that the running configuration on the active supervisor engine has
successfully synchronized with the redundant supervisor engine:
Switch# config terminal
Switch(config)# redundancy
Switch(config-red)# main-cpu
Switch(config-r-mc)# auto-sync standard
4d01h: %C4K_REDUNDANCY-5-CONFIGSYNC: The bootvar has been successfully synchronized to the
standby supervisor
4d01h: %C4K_REDUNDANCY-5-CONFIGSYNC: The config-reg has been successfully synchronized to
the standby supervisor
4d01h: %C4K_REDUNDANCY-5-CONFIGSYNC: The startup-config has been successfully synchronized
to the standby supervisor
4d01h: %C4K_REDUNDANCY-5-CONFIGSYNC: The private-config has been successfully synchronized
to the standby supervisor
The example above shows that the boot variable, the config-register, and the startup configuration from
the active supervisor engine have successfully synchronized to the redundant supervisor engine.
Step 9
Switch# redundancy reload peer
Reloads the redundant supervisor engine and brings it
back online (using the new release of the Cisco IOS
software).
Note Before proceeding to Step 10, ensure that the switch
is operating in RPR mode.
Step 10
Switch# redundancy force-switchover
Conducts a manual switchover to the redundant
supervisor engine. The redundant supervisor engine
becomes the new active supervisor engine using the new
Cisco IOS software image.
The old active supervisor engine reboots with the new
image and becomes the redundant supervisor engine.
Command Purpose

Table of Contents

Other manuals for Cisco 4500M

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 4500M and is the answer not in the manual?

Cisco 4500M Specifications

General IconGeneral
BrandCisco
Model4500M
CategoryNetwork Router
LanguageEnglish

Related product manuals