EasyManua.ls Logo

Cisco 4500M

Cisco 4500M
608 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7-10
Software Configuration Guide—Release 12.2(25)EW
OL-6696-01
Chapter 7 Environmental Monitoring and Power Management
Power Management
Special Considerations for the 1400 W DC Power Supply
Caution Do not mix the 1400 W DC power supply with any other power supply, even for a hot swap or other
short-term emergency. Doing so can seriously damage your switch.
Keep in mind the following guidelines when using a 1400 W DC power supply with your Catalyst 4500
series switch:
The 1400 W DC power supply works with a variety of DC sources. The DC input can vary from
300 W to 7500 W. Refer to the power supply documentation for additional information.
The supervisor engine cannot detect the DC source plugged into the 1400 W DC power supply. If
you are using the 1400 W DC power supply, use the power dc input command to set the DC input
power. For more information on this command, see the “Configuring the DC Input for a Power
Supply” section on page 7-11.
Table 7-3 Available Power for Switch Power Supplies
Power Supply Redundant Mode (W) Combined Mode (W) Sharing Ratio
1000 W AC Chassis
1
= 1000
PoE = 0
1. Chassis power includes power for the supervisor(s), all line cards, and the fan tray.
Chassis = 1667
PoE = 0
2/3
1300 W AC Chassis (max) = 1000
PoE (max) = 800
Chassis + PoE + Backplane <
1300
Chassis (min) = 767
PoE (max) = 1333
Chassis (max) = 1667
PoE (min) = 533
Chassis + PoE +
Backplane <
2200
2/3
1400 W DC Chassis (min) = 200
Chassis (max) = 1360
PoE (max)
2
= (DC Input
3
-
[Chassis (min) + Backplane] /
0.75) * 0.96
2. The efficiency for the 1400 W DC power supply is 0.75, and 0.96 is applied to PoE.
3. DC input can vary for the 1400 W DC power supply and is configurable. For more information, see “Special Considerations
for the 1400 W DC Power Supply” on page 10.
Chassis = 2267
4
PoE
5
4. Not available for PoE.
5. Not available for PoE.
Chassis—2/3
PoE—0
1400 W AC Chassis = 1360
PoE = 0
6
6. No voice power.
Chassis = 2473
PoE = 0
9/11
2800 W AC Chassis = 1360
PoE = 1400
Chassis = 2473
PoE = 2333
Chassis
7
—9/11
PoE
8
—2/3
7. Data-only.
8. Inline power.

Table of Contents

Other manuals for Cisco 4500M

Related product manuals