xxi
Software Configuration Guide—Release 12.2(25)EW
OL-6696-01
Preface
This preface describes who should read this document, how it is organized, and its conventions. The
preface also tells you how to obtain Cisco documents, as well as how to obtain technical assistance.
Audience
This guide is for experienced network administrators who are responsible for configuring and
maintaining Catalyst 4500 series switches.
Organization
This guide is organized into the following chapters:
Chapter Title Description
Chapter 1 Product Overview Presents an overview of the Cisco IOS software for
the Catalyst 4500 series switches
Chapter 2 Command-Line Interfaces Describes how to use the CLI
Chapter 3 Configuring the Switch for the
First Time
Describes how to perform a baseline configuration
of the switch
Chapter 4 Configuring Interfaces Describes how to configure non-layer-specific
features on Fast Ethernet, Gigabit Ethernet, and
10-Gigabit Ethernet interfaces
Chapter 5 Checking Port Status and
Connectivity
Describes how to check module and interface status
Chapter 6 Configuring Supervisor Engine
Redundancy Using RPR and SSO
Describes how to configure RPR and SSO on the
Catalyst 4507R and 4510R switches
Chapter 7 Environmental Monitoring and
Power Management
Describes how to configure power management and
environmental monitoring features
Chapter 8 Configuring Power over Ethernet Describes how to configure Power over Ethernet
(PoE)
Chapter 9 Configuring Switches with
Web-based Tools
Describes how to install and configure Network
Assistant and Embedded CiscoView
To Next Page
Loading...
Need help?
General
