Index
IN-6
Software Configuration Guide—Release 12.2(25)EW
OL-6696-01
installing and configuring 9-14
overview 9-13
enable command 3-9, 3-21
enable mode 2-5
encapsulation types 12-3
Enhanced Interior Gateway Routing Protocol
See EIGRP
environmental monitoring
LED indications
7-2
SNMP traps 7-2
supervisor engine 7-2
switching modules 7-2
using CLI commands 7-1
EtherChannel
channel-group group command
17-7, 17-10
configuration guidelines 17-5
configuring 17-6 to 17-14
configuring Layer 2 17-9
configuring Layer 3 17-6
interface port-channel command 17-7
lacp system-priority
command example
17-12
modes 17-3
overview 17-1
PAgP
Understanding
17-3
physical interface configuration 17-7
port-channel interfaces 17-2
port-channel load-balance command 17-12
ports, 802.1X authentication not supported in 31-13
removing 17-14
removing interfaces 17-13
explicit host tracking
enabling
18-8
extended range VLANs
See VLANs
Extensible Authentication Protocol over LAN
31-2
Exterior Gateway Protocol
See EGP
F
FastDrop
clearing entries
25-20
displaying entries 25-19
overview 25-10
FIB
description
24-2
See also MFIB
filtering
in a VLAN
35-12
non-IP traffic 35-11
flags 25-11
Flash memory
configuring router to boot from
3-24
loading system images from 3-23
security precautions 3-23
flooded traffic, blocking 37-2
forward-delay time (STP)
configuring
14-18
forwarding information base
See FIB
G
gateway
See default gateway
global configuration mode
2-5
Guest-VLANs
configure with 802.1X
31-17, 31-18
H
hardware and software ACL support 35-5
hardware switching 24-5
hello time (STP)
configuring
14-17
history
CLI
2-3
To Next Page
Loading...
