Index
IN-3
Cisco 7206 Installation and Configuration Guide
OL-5202-02
Ethernet and serial interface configuration 4-8
formatting a new Flash memory card 5-9
replacing a port adapter 5-4
replacing a service adapter 5-4
setup command facility 4-6
show diag command output 1-22, 5-1
show environment all command output 1-35
show environment command output 1-33
show environment last command output 1-34
show interfaces command output 1-29
show version command output 1-13, 5-1
EXEC mode 4-1
exhaust air 1-33
F
fan failures 1-35
field-replaceable units (FRUs) 1-7
filler panels
port adapter
2-8
power supply 2-8
Flash memory
copy command
5-12
copying between cards 5-11
copying files 5-10
Flash memory card
formatting a new Flash memory card
5-9
inserting and removing a Flash memory card 5-7
memory options 1-27
physical description 1-27
Flash memory disk
memory options
1-28
physical description 1-27
FRUs, listing 1-7
G
global parameters, configuring 4-3
ground receptacles, chassis 1-4
H
handles
I/O controller
1-2
network processing engine 1-4
port adapter 1-3, 5-5
power supply 1-24
hardware address 1-28
I
I/O controller
handling
2-2
LEDs 6-3
MII receptacle 3-17
normal startup 6-3
physical description 1-14
reset button 1-18
RJ-45 port 3-18
subsystem for troubleshooting 6-6
identifying startup problems 6-3
IGRP 4-5
installation
checking shipping container
2-11
checklist 2-10
configuring Cisco 7206 4-2
connecting I/O controller cables 3-14
connecting port adapter cables 3-14
connecting power 3-20
grounding the chassis 3-12
initial configuration information 2-9
installing brackets on the chassis 3-5
installing chassis in a rack 3-2
installing chassis on a tabletop (general
installation)
3-9
interface parameters 4-6
preparing for 2-1
To Next Page
Loading...
