Index
IN-4
Cisco 7206 Installation and Configuration Guide
OL-5202-02
starting the Cisco 7206 3-24
tools for 2-8
interface
configuration
4-6
parameters 4-6
interference, radio frequency 2-2
Interior Gateway Routing Protocol (IGRP) 4-5
interior routing protocol (IGRP), setting 4-5
Internet Package Exchange (IPX), configuring 4-5
IP, setting routing protocols for 4-5
IPX 4-5
L
LEDs
DC OK
3-24
enabled on interface processors 3-24
I/O controller 6-3
PCMCIA slots 0 and 1 1-22
power supply 1-24, 6-3
lifting the chassis 3-9
M
messages
environmental
1-33
fan failure 2-8
MII receptacle on I/O controller, pinouts 3-18
modifications to configuration, reviewing 4-10
N
network processing engine
handling
2-2
physical description 1-7
subsystem for troubleshooting 6-7
system management functions 1-9
nonvolatile random-access memory
See NVRAM
4-10
normal status level, environmental monitor 1-32, 1-33
note, description ix
numbering
logical interface
1-28
port adapter slot 1-28
NVRAM
log
1-32
saving and viewing contents 4-10
See nonvolatile random-access memory
O
OIR, functional description 1-30
operating conditions for chassis 1-25, 2-2
out-of-tolerance temperature condition 1-32
out-of-tolerance voltage condition 1-32
overheating, preventing 2-8
overtemperature conditions 6-3
P
password, enable and enable secret 4-1
physical description
field-replaceable units
Flash memory cards
1-27
Flash memory disks 1-27
I/O controller 1-14
network processing engine 1-7
port and service adapters 1-24
power supplies 1-24
pinouts
MII receptacle on I/O controller
3-18
RJ-45 receptacle on I/O controller 3-19
port adapters
filler
2-8
handling 2-2, 5-5
logical interface numbering 1-28
To Next Page
Loading...
