Cisco 7600 Series - Page 11

11
Guide to Supported Hardware for Cisco 7600 Series Routers with Cisco IOS Release 15S
OL-10362-13
Guide to Supported Hardware for Cisco 7600 Series Routers with Cisco IOS Release 12.2SR
Supported Hardware
• These service modules:
– WS-SVC-AON-1-K9—Application-Oriented Networking Module
– WS-SVC-AGM-1-K9—Anomaly Guard Module
– WS-SVC-ADM-1-K9—Traffic Anomaly Detector Module
– WS-SVC-MWAM-1—Multi-Processor WAN Application Module
• Supervisor Engine 32 does not support these software features and commands:
– Protocol independent multicast (PIM) snooping designated-router flooding configurability
– NetFlow version 9
– Egress multicast replication
– Multicast replication mode detection
– All fabric configuration commands
Product ID
(append “=” for spares)
Power
Required Product Description
Minimum
Software Version
WS-SUP32-10GE-3B
2.39 A@42 V Supervisor Engine 32:
• One 10/100/1000 Mbps RJ-45 port
• WS-SUP32-10GE—two Gigabit Ethernet ports
(requires XENPAKs)
• WS-SUP32-GE—eight Gigabit Ethernet SFP ports (requires
Gigabit Ethernet SFPs)
• 512-MB DRAM
• 256-MB bootflash
• Policy Feature Card 3B (PFC3B); see the
“RSP720-3C-10GE” section on page 19
• Multilayer Switch Feature Card 2A (MSFC2A):
– 512-MB DRAM
– 64-MB bootflash
12.2(33)SRA
WS-SUP32-GE-3B
1.89 A@42 V
Software Version SFPs Supported
12.2(33) SRE onwards DWDM-SFP-3033
=