21
Guide to Supported Hardware for Cisco 7600 Series Routers with Cisco IOS Release 15S
OL-10362-13
Guide to Supported Hardware for Cisco 7600 Series Routers with Cisco IOS Release 12.2SR
Supported Hardware
• High-availability features such as NonStop Forwarding with Stateful Switchover (NSF/SSO) and
In-Service Software Upgrade (ISSU) are not supported. Only Route Processor Redundancy (RPR)
mode is supported.
• The uplinks on the standby RSP720-10GE are not active. This restriction exists because the uplink
ports must perform lookups on the active RSP, which is not possible in RPR mode.
• Broadband aggregation features are not supported.
• The RSP720-10GE is on limited orderability. General orderability is expected with the 12.2(33)SRE
release.
RSP720-3CXL-10GE
Product ID
(append “=” for spares)
Power
Required Product Description
Minimum
Software Version
RSP720-3CXL-10GE
7.33 A@42 V Route Switch Processor 720 with PFC3CXL:
• Two 10 Gigabit Ethernet (10-GE) uplink ports support
10-Gbps X2 modules
• Three Gigabit Ethernet (1-GE) uplink ports: two ports support
1-Gbps small form-factor pluggable (SFP) module; one port
supports 10/100/1000-Mbps RJ-45 connector
• Integrated 720-Gbps switch fabric
• PFC3CXL (high-capacity) and MSFC4 with 512-MB
bootflash, 4-MB NVRAM, 4-MB ROMmon, and several
DRAM options:
–
Route processor (RP): 1- to 2-GB DRAM (default 2
GB)
–
Switch processor (SP): 1- to 2-GB DRAM (default 1
GB)
• One CompactFlash Type II slot (on front panel) and one
2-GB internal CompactFlash (1 GB each for RP and SP)
• Requires larger power supplies and a high-speed fan tray
• QoS port architecture, 10-GE ports (Rx/Tx): 8q8t/1p7q8t
(CoS)
• QoS port architecture, 1-GE ports (Rx/Tx): 2q8t/1p3q8t
12.2(33)SRC
Software Version SFPs Supported
12.2(33) SRE1, 15.0(1)S CWDM-SFP-1470=
To Next Page
Loading...
