Cisco 7600 Series - Page 47

47
Guide to Supported Hardware for Cisco 7600 Series Routers with Cisco IOS Release 15S
OL-10362-13
Guide to Supported Hardware for Cisco 7600 Series Routers with Cisco IOS Release 12.2SR
Supported Hardware
10/100/1000 Ethernet Switching Modules
WS-F6K-VPWR
None PoE daughtercard for WS-X6348-RJ-45, WS-X6348-RJ-21V, WS-X6148-RJ-45,
and WS-X6148-RJ-21
With Supervisor Engine 720 12.2(33)SRA
Product ID
(append “=” for spares)
Power
Required Product Description
Minimum
Software Version
WS-X6748-GE-TX
7.00 A@42 V 48-port 10/100/1000 RJ-45
• CEF720 with WS-X6700-CFC (adds 0.75 A@42 V)
• dCEF720 with WS-F6700-DFC3BXL (adds 3.30 A@42 V)
• dCEF720 with WS-F6700-DFC3B (adds 3.00 A@42 V)
• Supports egress multicast replication
• QoS architecture:
– With DFC3: 2q8t/1p3q8t
– With CFC: 1q8t/1p3q8t
• Number of ports: 48
Number of port groups: 4
Port ranges per port group: 1–12, 13–24, 25–36, 37–48
Supported with Supervisor Engine 720 12.2(33)SRA
Supported with RSP 720-1GE 12.2(33)SRB
Supported with RSP 720-10GE 12.2(33)SRC
Note
•
WS-X6748-GE-TX requires one of the following:
– WS-F6700-DFC3BXL (3.30 A@42 V)
– WS-F6700-DFC3B (3.00 A@42 V)
– WS-X6700-CFC (0.75 A@42 V)
• WS-X6748-GE-TX ships with WS-X6700-CFC installed unless ordered with WS-F6700-DFC3BXL or
WS-F6700-DFC3B.
• WS-X6748-GE-TX is supported in the WS-C6503-E chassis.
• WS-X6748-GE-TX is not supported in the WS-C6503 and CISCO7603 chassis.
• In a 13-slot chassis, WS-X6748-GE-TX is supported only in slots 9 through 13 and does not power up in other slots.
• On WS-X6748-GE-TX ports, STP BPDUs are not exempt from Traffic Storm Control suppression. Do not configure
Traffic Storm Control on STP-protected WS-X6748-GE-TX ports that interconnect network devices.
Product ID
(append “=” for spares)
Power
Required Product Description
Minimum
Software Version