Cisco 7600 Series Hardware

59
Guide to Supported Hardware for Cisco 7600 Series Routers with Cisco IOS Release 15S
OL-10362-13
Guide to Supported Hardware for Cisco 7600 Series Routers with Cisco IOS Release 12.2SR
Supported Hardware
CT3/T1 Channelized/Unchannelized
Note OSM-12CT3/T1 has mini-SMB connectors for use with 75-ohm copper coaxial cable.
OC-12 ATM
Note Also has four Layer 2 LAN ports.
SPA Interface Processors (SIPs)
Note See the Release Notes for Cisco IOS Release 12.2SR on the Cisco 7600 Series Routers for information
about additional procedures required to support SIPs with Cisco IOS Release 12.2(33)SRA and later
releases.
Product ID
(append “=” for spares)
Power
Required Product Description
Minimum
Software Version
OSM-12CT3/T1
2.80 A@42 V 12-port channelized/unchannelized CT3/T1; CEF256
With Supervisor Engine 720 12.2(33)SRA
Product ID
(append “=” for spares)
Power
Required Product Description
Minimum
Software Version
OSM-2OC12-ATM-MM+
OSM-2OC12-ATM-SI+
4.00 A@42 V Enhanced 2-port OC-12/STM-4 ATM OSM, MM; CEF256
Enhanced 2-port OC-12/STM-4 ATM OSM, SM-IR; CEF256
With Supervisor Engine 720 12.2(33)SRA
Product ID
(append “=” for spares)
Power
Required Product Description
Minimum
Software Version
7600-SIP-600
8.14 A@42 V SPA Interface Processor-600
Supported with Supervisor Engine 720 12.2(33)SRA
With RSP720-10GE 12.2(33)SRE
With RSP720 12.2(33)SRB
Note Supervisor Engine 32 does not support 7600-SIP-600.
7600-SIP-400
6.31 A@42 V SPA Interface Processor-400
With Supervisor Engine 720 12.2(33)SRA
With Supervisor Engine 32 12.2(33)SRA
Note For release 12.2(33)SRB, oversubscription is supported.

Cisco 7600 Series Specifications

General

Category	Network Router
Port Density	Varies by module
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet
Redundancy	Power supplies
Power Supply	AC or DC, Redundant options available
Operating System	Cisco IOS XR
Management	CLI, SNMP
Form Factor	Modular
Dimensions	Varies by chassis model
Weight	Varies by chassis model and configuration
Chassis Slots	6, 9, or 13