Cisco 7800 Series Manual

The following table shows the changes made for Firmware Release 11.0(1).
Table 10: Cisco IP Phone 7800 User Guide revisions for Firmware Release 11.0(1).
Updated SectionRevision
Report All Phone Issues , on page 20Added the following section for Problem Report Tool
support
Shared LinesRevised the following sections for cBarge and Barge
Turn On Do Not DisturbRevised the following sections for Do Not
Disturb(DND)
Feature Support
This document describes all the features that the device supports. However, not all features may be supported
with your current configuration. For information on supported features, contact your administrator.
Phone Setup
Your administrator sets up your phone and connects it to the network. If your phone is not set up and connected,
contact your administrator for instructions.
Adjust the Handset Rest
If your phone is wall-mounted or if the handset slips out of the cradle too easily, you may need to adjust the
handset rest to ensure that the receiver does not slip out of the cradle.
Figure 2: Adjust the Handset Rest
Your Phone
5
Your Phone
Feature Support

Cisco 7800 Series Specifications

General

Wireless	No
Video Support	No
PoE	Yes, 802.3af/at
Audio Codec Support	G.711, G.722, G.729, iLBC
Network Protocols	SIP, SDP, IPv4, IPv6, UDP, TCP, DNS, TFTP, HTTP, HTTPS, DHCP
Security Features	802.1X, TLS, SRTP
Power Options	PoE
Headset Port	3.5mm
Buttons	Line keys, navigation cluster, softkeys, mute, speakerphone, headset, volume control
Bluetooth	No
Ethernet Switch	Yes, 2-port 10/100/1000
USB Port	Yes, for headset (7875)