Change the Service Mode
When your phone connects to the existing server, you hear a beep tone that exists for 5 seconds. You also
view an alert message window which indicates that you can change the service mode to Huron.
Procedure
Step 1 To change the service mode:
• Press the Select key on the phone.
• Select Settings > Admin Settings > Reset Settings > Service Mode.
Your phone deactivates your VPN, and then restarts.
Step 2 Press Reset to change the service to Huron.
Step 3 Press Cancel to retain the existing service.
Activate and Sign In to Your Phone
You may need to activate or sign in to your phone. Activation happens once for your phone, and connects the
phone to the call control system. Your administrator gives you your sign-in and activation credentials.
Sign In to Your Phone
Before you begin
Get your user ID and PIN or password from your administrator.
Procedure
Step 1 Enter your user ID in the User ID field.
Step 2 Enter your PIN or password in the PIN or Password field, then press Submit.
Sign In to Your Extension from Another Phone
You can use Cisco Extension Mobility to sign in to a different phone in your network and have it act the same
as your phone. After you sign in, the phone adopts your user profile, including your phone lines, features,
established services, and web-based settings. Your administrator sets you up for the Cisco Extension Mobility
service.
Before you begin
Get your user ID and PIN from your administrator.
Your Phone
8
Your Phone
Change the Service Mode
To Next Page
Loading...
Need help?
General
