Cisco 7942G - Page 84

4-20
Cisco Unified IP Phone 7962G and 7942G Administration Guide for Cisco Unified Communications Manager 6.1(3)
OL-17679-01
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Device Configuration Menu
Recording Tone Local
Vo l u m e
Indicates the loudness setting for the beep tone
that is received by the party whose phone has the
Recording Tone option enabled.
This setting applies for each listening device
(handset, speakerphone, headset).
Range: 0 percent (no tone) to 100 percent (same
level as current volume setting on the phone).
Default: 100
See also: Recording Tone
From Cisco Unified Communications Manager
Administration, choose Device
> Phone > Phone
Configuration.
Recording Tone
Remote Volume
Indicates the loudness setting for the beep tone
that the remote party receives. The remote party
is the party who is on a call with the party whose
phone has the Recording Tone option enabled.
Range: 0 percent to 100 percent. (0 percent is
-66 dBM and 100 percent is -3 dBM.)
Default: 84 percent (-10dBM)
See also: Recording Tone
From Cisco Unified Communications Manager
Administration, choose Device
> Phone > Phone
Configuration.
Recording Tone
Duration
Indicates the length of time in milliseconds for
which the beep tone plays.
If the value you configure here is less than one
third the interval, then this value overrides the
default provided by the Network Locale.
Range: 0 to 3000
Note For some Network Locales that use a
complex cadence, this setting applies
only to the first beep tone.
See also: Recording Tone
From Cisco Unified Communications Manager
Administration, choose Device
> Phone > Phone
Configuration.
Wideband Headset Indicates whether wideband is enabled or
disabled for the headset.
Default: Disabled
• If Wideband Headset UI Control is enabled,
you or the user can use the phone and choose
> User Preferences > Audio
Preferences > Wideband Headset.
• If Wideband Headset UI Control is disabled,
from Cisco Unified Communications
Manager Administration, choose Device >
Phone > Phone Configuration to set this
value.
Note If you allowed this option to be user
controllable (in the Wideband Headset UI
Control option), the user-configured value
takes precedence.
Table 4-13 Media Configuration Menu Options (continued)
Option Description To Change