Cisco 7942G - Page 89

4-25
Cisco Unified IP Phone 7962G and 7942G Administration Guide for Cisco Unified Communications Manager 6.1(3)
OL-17679-01
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Device Configuration Menu
CDP: PC Port Indicates whether CDP is supported on the PC port
(default is enabled).
Enable CDP on the PC port when Cisco VT
Advantage/Unified Video Advantage (CVTA) is
connected to the PC port. CVTA does not work
without CDP interaction with the phone.
Note When CDP is disabled in Cisco Unified
Communications Manager, a warning is
displayed, indicating that disabling CDP
on the PC port prevents CVTA from
working.
Note The current PC and switch port CDP
values are shown on the Settings menu.
From Cisco Unified Communications Manager
Administration, choose Device > Phone.
CDP: SW Port Indicates whether CDP is supported on the switch
port (default is enabled).
• Enable CDP on the switch port for VLAN
assignment for the phone, power negotiation,
QoS management, and 802.1x security.
• Enable CDP on the switch port when the
phone is connected to a Cisco switch.
Note When CDP is disabled in Cisco Unified
Communications Manager, a warning is
presented, indicating that CDP should be
disabled on the switch port only if the
phone is connected to a non-Cisco switch.
Note The current PC and switch port CDP
values are shown on the Settings menu.
From Cisco Unified Communications Manager
Administration, choose Device > Phone.
Table 4-17 Network Configuration Menu Options (continued)
Option Description To Change