Cisco 8961 Setup

Procedure
Step 1
Insert the curved connectors into the lower slots.
Step 2
Lift the footstand until the connectors snap into the upper slots.
Connecting and disconnecting the footstand may require a little more force than you expect.Note
Adjust Phone Display Viewing Angle
The viewing angle of the phone display can be adjusted according to your preference.
Procedure
Hold the handset and cradle with your left hand, hold the right side of the bezel (to the right of the display)
with your right hand, and then move your hands back and forth in opposite directions to adjust the angle.
The following figure shows the display angle of the Cisco Unified IP Phone 9971.
Cisco Unified IP Phone 8961, 9951, and 9971 User Guide for Cisco Unified Communications Manager 10.0 (SIP)
2
Phone Setup
Adjust Phone Display Viewing Angle

Cisco 8961 Specifications

General

Resolution	640 x 480 pixels
Display	5-inch TFT color display
Ethernet	10/100/1000 Mbps
Power	IEEE 802.3af Power over Ethernet (PoE) Class 3
Connectivity	Two-port Gigabit Ethernet switch
Buttons	4 softkeys
USB Port	Yes, supports USB 2.0
Headset Jack	Yes, dedicated headset port
Speakerphone	Full-duplex speakerphone
Codec Support	G.711, G.722, G.729, iLBC
Security	802.1X authentication, TLS, SRTP, HTTPS