2-11
Cisco Aironet 1540 Series Outdoor Access Point Hardware Installation Guide
Chapter 2 Installing the Access Point
Installing AP Cover AIR-ACC1540-CVR=
Installing AP Cover AIR-ACC1540-CVR=
You can install a cover AIR-ACC1540-CVR=, which also acts as a a solar shield. The cover can be
installed before or after all connections are made.
Step 1 Position and slide the cover over the AP as shown in Figure 2-5.
Step 2 Align the two holes on each side of the cover with the screw holes on corresponding side of the AP.
Step 3 Insert and fasten #8-32 screws through the screw holes in the cover, into the AP. Tighten the screws to
10 lb-in.
Figure 2-5 Installing the Cover on the AP
1 Solar Shield. 3 Two of four #8-32 screws, circular washers, and split
washers.
2 Four screw holes for fastening the solar cover. Two on
each side of the AP.
354960
2
3
1
2
To Next Page
Loading...
