2-6
Cisco Aironet 1540 Series Outdoor Access Point Hardware Installation Guide
Chapter 2 Installing the Access Point
Mounting the Access Point
Wall Mounting the Access Point with AIR-ACC1530-PMK1=
The AIR-ACC1530-PMK1= mounting kit contains a mounting bracket for wall mounting or pole
mounting.
You can use the mounting bracket as a template to mark the positions of the mounting holes for your
installation, install the mounting bracket, and then attach the access point to the bracket.
Table 2-1 lists the materials needed for this installation.
Caution The mounting wall, attaching screws, and wall anchors must be able to support a 50 lb (22.7 kg) static
weight.
To mount the access point vertically on a wall, follow these instructions:
Step 1 Use the mounting bracket as a template to mark four screw hole locations on the mounting wall. The
mounting bracket screw hole locations are shown in
Figure 2-2. The dimensions of the mounting
bracket is shown in
Figure 2-3.
Step 2 Use four screws and, if required, wall anchors to attach the mounting plate to the mounting surface.
These screws and anchors are to be sourced independently.
Note You can use an exterior-grade plywood backboard to mount the access point to stucco, cement,
or dry wall.
Table 2-1 Materials Required to Mount Access Point Using AIR-ACC1530-PMK1=
Materials Required In Kit?
Ground lug and screws (provided with access
point)
Yes
Wall Mount Bracket Yes
Four M6 x 12-mm Hex-head Bolts Yes
Crimping tool for ground lug, Panduit CT-720
with CD-720-1 die (
http://www.panduit.com)
No
Four wall mounting screws No
Four wall anchors (specified for all material) No
Drill bit for wall anchors No
Electric drill and standard screwdriver No
#6 AWG ground wire No
Shielded outdoor-rated Ethernet (CAT5e or
better) cable
No
Grounding block No
Grounding rod No
10-mm box-end wrench or socket set No
To Next Page
Loading...
