Cisco AIR-AP1832I K9C Series User Manual

12
Figure 3 Pre-Installation Configuration Setup
To perform pre-installation configuration, perform the following steps:
Step 1 Make sure that the Cisco wireless LAN controller DS port is connected to the network. Use
the CLI, web-browser interface, or Cisco Prime Infrastructure procedures as described in the
appropriate Cisco wireless LAN controller guide.
a. Make sure that access points have Layer 3 connectivity to the Cisco wireless LAN controller
Management and AP-Manager Interface.
b. Configure the switch to which your access point is to attach. See the Cisco Wireless LAN
Controller Configuration Guide for the release you are using, for additional information.
c. Set the Cisco wireless LAN controller as the master so that new access points always join with
it.
d. Make sure DHCP is enabled on the network. The access point must receive its IP address
through DHCP.
e. CAPWAP UDP ports must not be blocked in the network.
f. The access point must be able to find the IP address of the controller. This can be
accomplished using DHCP, DNS, or IP subnet broadcast. This guide describes the DHCP
method to convey the controller IP address. For other methods, refer to the product
documentation. See also the “Configuring DHCP Option 43” section on page 26 for more
Controller
Layer 3
devices
Cisco wireless
access points
272488

Cisco AIR-AP1832I K9C Series Specifications

General

Model	AIR-AP1832I-K9C
Category	Wireless Access Point
Wi-Fi Standards	802.11a/b/g/n/ac
Wi-Fi Generation	Wi-Fi 5
Wireless LAN Standard	802.11ac
Frequency Bands	2.4 GHz, 5 GHz
Antenna Type	Internal
Number of Antennas	3
USB Ports	1x USB 2.0
Ethernet Ports	1x 10/100/1000BASE-T (RJ-45)
Power Options	PoE, Power Adapter
Form Factor	Ceiling mount
Maximum Data Rate	1.3 Gbps
Operating Temperature	0°C to 40°C
Storage Temperature	-30°C to 70°C (-22°F to 158°F)
Security Features	WPA, WPA2, 802.1X
MIMO	3x3 MIMO with three spatial streams
Data Transfer Rate	Up to 867 Mbps on 5 GHz, 300 Mbps on 2.4 GHz
Dimensions	200 x 200 x 45 mm