Cisco AS5350 - Universal Access Server - Page 124

5-26
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
OL-3418-02 B0
Chapter5 Managing and Troubleshooting the UniversalPort Card
Interface Queue Wedge Monitor
Step 6 Enable the Interface Queue Wedge Monitor again.
AS5400##conf t
Enter configuration commands, one per line. End with CNTL/Z.
AS5400#(config)#interface-monitor enable
AS5400#(config)#^Z
AS5400##
AS5400##
AS5400##
12:00:50: %HHM-3-INTFWEDGE: Async4/00 Input Queue Wedge
12:00:53: %HHM-3-INTFWEDGE: Async4/01 Input Queue Wedge
12:00:56: %HHM-3-INTFWEDGE: Async4/02 Input Queue Wedge
12:00:59: %HHM-3-INTFWEDGE: Async4/03 Input Queue Wedge
12:01:02: %HHM-3-INTFWEDGE: FastEthernet0/0 Input Queue Wedge
12:01:05: %HHM-3-INTFWEDGE: FastEthernet0/1 Input Queue Wedge
12:01:26: %HHM-3-INTFWEDGE: Virtual-Access2 Input Queue Wedge
12:01:29: %HHM-3-INTFWEDGE: Virtual-Access3 Input Queue Wedge
AS5400##
AS5400##
Step 7 Show interface wedge process running again. (Process is running now.)
AS5400##sh proc cpu | i Intf
39 8 110 72 0.00% 0.00% 0.00% 0 Intf Wedge Monit
AS5400##
Step 8 Show wedge input.
Here is the o/p again
---------------------
AS5400##sh wedged-interfaces input
Interface Time Since Wedge
Async4/00 00:24:14
Async4/01 00:24:06
Async4/02 00:23:42
Async4/03 00:23:37
FastEthernet0/0 12:00:44
FastEthernet0/1 12:01:01
Virtual-Access2 00:11:02
Virtual-Access3 00:11:02