Cisco AS5350 - Universal Access Server - Page 123

5-25
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
OL-3418-02 B0
Chapter 5 Managing and Troubleshooting the Universal Port Card
Interface Queue Wedge Monitor
FastEthernet0/0 00:26:29
FastEthernet0/1 00:26:44
Virtual-Access2 00:40:12
Virtual-Access3 00:40:12
AS5400##
Step 9 Show interface wedge process running again. (Process is running now.)
AS5400##show proc cpu | i Intf
39 0 25 0 0.00% 0.00% 0.00% 0 Intf Wedge Monit
Wedge Interface Input Procedure
The following procedure shows an example of how to enable, disable, and show the results of wedged
interface input:
Step 1 Show wedged interfaces. (Interfaces are already wedged.)
AS5400##sh wedged-interfaces input
Interface Time Since Wedge
Async4/00 00:21:58
Async4/01 00:21:51
Async4/02 00:21:26
Async4/03 00:21:21
FastEthernet0/0 11:58:28
FastEthernet0/1 11:58:46
Virtual-Access2 00:08:46
Virtual-Access3 00:08:46
AS5400##
AS5400##
Step 2 Show interface wedge process running.
AS5400##sh proc cpu | i Intf
39 0 21 0 0.00% 0.00% 0.00% 0 Intf Wedge Monit
AS5400##
AS5400##
AS5400##
Step 3 Disable interface monitor.
AS5400##conf t
Enter configuration commands, one per line. End with CNTL/Z.
AS5400#(config)#no interface-monitor enable
AS5400#(config)#^Z
AS5400##
AS5400##
AS5400##
Step 4 Show interface wedge process running again. (No process is running now.)
AS5400##sh proc cpu | i Intf
AS5400##
AS5400##
Step 5 Show wedged interface input. (No input.)
AS5400##show wedged-interfaces output
Interface Time Since Wedge
AS5400##
AS5400##