Contents
v
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
OL-3418-02 B0
External Clock 3-31
Free-Running Clock 3-32
Configuration Examples 3-33
Verify 3-33
Enabling IP Basic Setup 3-36
Testing Asynchronous Shell Connections 3-37
Verifying the Final Running-Configuration 3-39
Saving Configuration Changes 3-41
Configure 3-41
Where to Go Next 3-42
CHAPTER
4 Continuing Configuration Using the Command-Line Interface 4-1
Configuring Synchronous Serial Interfaces for WAN Support 4-2
Configure 4-2
Verify 4-3
Configuring CT1 Channel Groups 4-3
Configure 4-4
Verify 4-4
Configuring ISDN NFAS on CT1 PRI Groups 4-5
Configure 4-5
Take a Channel or Interface Out of Service 4-6
Verify 4-6
Configuring E1 R2 Signaling 4-6
Configure 4-7
Country Codes for R2 Signaling 4-9
Verify 4-9
Configuring Alarms 4-10
Configure 4-10
Verify 4-11
Saving Configuration Changes 4-12
Configure 4-12
Where to Go Next 4-12
CHAPTER
5 Managing and Troubleshooting the Universal Port Card 5-1
Managing SPE Performance Statistics 5-2
Configuration 5-2
Viewing SPE Performance Statistics 5-3
Managing Ports 5-5
To Next Page
Loading...
