EasyManuals Logo

Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router User Manual

Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router
378 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #293 background imageLoading...
Page #293 background image
9-5
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
OL-16506-10
Chapter 9 Using the Management Ethernet Interface
Common Ethernet Management Tasks
Telnetting over the Management Ethernet Interface
Telnetting can be done through the VRF using the Management Ethernet interface.
In the following example, the router telnets to 172.17.1.1 through the Management Ethernet interface
VRF:
Router# telnet 172.17.1.1 /vrf Mgmt-intf
Pinging over the Management Ethernet Interface
Pinging other interfaces using the Management Ethernet interface is done through the VRF.
In the following example, the router pings the interface with the IP address of 172.17.1.1 through the
Management Ethernet interface:
Router# ping vrf Mgmt-intf 172.17.1.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 172.17.1.1, timeout is 2 seconds:
.!!!!
Success rate is 80 percent (4/5), round-trip min/avg/max = 1/1/1 ms
Copy Using TFTP or FTP
To copy a file using TFTP through the Management Ethernet interface, the ip tftp source-interface
GigabitEthernet 0 command must be entered before entering the copy tftp command because the copy
tftp command has no option of specifying a VRF name.
Similarly, to copy a file using FTP through the Management Ethernet interface, the ip ftp
source-interface GigabitEthernet 0 command must be entered before entering the copy ftp command
because the copy ftp command has no option of specifying a VRF name.
TFTP Example
Router(config)# ip tftp source-interface gigabitethernet 0
FTP Example
Router(config)# ip ftp source-interface gigabitethernet 0
NTP Server
To allow the software clock to be synchronized by a Network Time Protocol (NTP) time server over the
Management Ethernet interface, enter the ntp server vrf Mgmt-intf command and specify the IP
address of the device providing the update.
The following CLI provides an example of this procedure.
Router(config)# ntp server vrf Mgmt-intf 172.17.1.1

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router and is the answer not in the manual?

Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router Specifications

General IconGeneral
BrandCisco
ModelASR1000-RP1 - ASR 1000 Series Route Processor 1 Router
CategoryNetwork Router
LanguageEnglish

Related product manuals